I ended up getting 50 of each of the M6 and 1/4-20 SS roll-in t-nuts for future accessories. I went with the M6 for the Eyenuts because there are more options for M6 SS Eyenuts with the correct bolt length needed than 1/4-20. The M6 and 1/4-20 are the only size roll-in t-nuts that fit the Prinsu 10-Series t-slots.

One other thing to note is that you can get 1/4-20 SS roll-in t-nuts as well from the same guy on eBay here: One thing to keep in mind is that you will need to get a precise bolt length for whatever application you are using so not to bottom out the bolt on the t-slot when tightening. If you have large fingers you may need needle nose pliers or a flat head screw driver to assist.Īs you'll see you and can image, these roll-in t-nuts can be used for a lot of different applications. flick the roll in t-nut to one side and then lift out.Screw the Eyebolt with washer stack into the roll-in t-nut.Insert the roll-in t-nut into the t-slot and center it up.First stack the washers on the Eyebolt in the following order: lock washer -> flat metal washer -> Nylon plastic washer.Once you have the items above the installation is simple:

I use these to protect the t-slot bars to prevent the anodizing from getting scrapped up.

Small Parts Nylon 6/6 Flat Washer, Plain Finish, Black, 1/4' Hole Size, 0.28' ID, 0.74' OD, 0.06' Nominal Thickness (Pack of 100)

10 series t slot eye bolt